Skip to Content
avatar image
Former Member

Restart successful Message in PI

Hi All,

I have a scenario where we created a BPM which calles three RFC's in sequence on ECC side one by one. The response of first RFC is the request for Second RFC.

Now we have a situtaion where our FA says if the Third RFC call is failed, she should be able to re start from second step again even if it was successful.

Now Question:

1. Is it possible to restart a sucessful message

2. If no, can it be possible to restart from ECC, just like the request came in from PI so that BPM continues.

Any help will be really appriciated.

Thanks

-Kulwant

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Best Answer
    Jul 22, 2009 at 06:01 AM

    hi,

    >>>1. Is it possible to restart a sucessful message

    there is a simple trick from my blog 😊

    /people/michal.krawczyk2/blog/2005/11/09/xi-restarting-successfully-processed-messages

    Regards,

    Michal Krawczyk

    Add comment
    10|10000 characters needed characters exceeded

    • hi,

      >>>Thanks for the quick reponse. But you mentioned that we cannot make use of this in PRD. Is there any soultion for PRD environment

      I mention that I should not and not cannot 😊

      you can also resend the same message easily in RWB - test message tab

      but the best/proper way would be to restart the message from the sender...

      Regards,

      Michal Krawczyk

  • avatar image
    Former Member
    Jul 22, 2009 at 06:01 AM

    Hi ,

    Checkout this blog which discusses about resending successful messages /people/michal.krawczyk2/blog/2005/11/09/xi-restarting-successfully-processed-messages

    Thanks

    Hamja

    Add comment
    10|10000 characters needed characters exceeded