cancel
Showing results for 
Search instead for 
Did you mean: 

User status

Former Member
0 Kudos

Hi Experts,

What customizing to be done so that whenever any user create notificatio or order on a equipment assigned with user status

( like sent for repair ).The system should through error message that this equipment is sent for repair.

AR.

Edited by: Amit Rana on Jul 20, 2009 12:18 PM

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Hi AR,

It is not possible to set the condition of creating a notication or maintenane order to the user status of the equipmet.

Check with some user exists IWOC0001 Create PM/CS Notification: Determination of Ref. Object and for order you dont have exit at save but at release you can check the status of the equipment IWO10002 PM Order: Customer Exit Before Release.

Regards,

Praveen

P745394
Active Contributor
0 Kudos

HI Praveen

In user status if you set "PM Processing Data" - forbidden & Set this Status in Equipment , It will not allow you to create Order or Notification , Check it once

Amit , you can try User Status once

how to create user status is been discussed in forum search for it.

Go to spro-PMCS - Master data in PMCS - basic settings - user Status , Click on New Create a User status , In User Status Create Two status One with Equipment sent to repair , for this Status if click binocular button , it will list all business trans , in that for "PM processing data" Click forbidden.

In Equipment input this Status & Set it whenever you send it outside , then check it will not allow u to create Order or Notification.

Regards,

Edited by: Srinivas Narayana Gowda on Jul 20, 2009 9:51 AM

Edited by: Srinivas Narayana Gowda on Jul 20, 2009 9:56 AM

Former Member
0 Kudos

Hi Srinivas Narayana,

thanks for the info, actually i was looking for the option like create maintenance notification or order kind of thing.

I have tested with your inputs.

Its working, no need of user exits.

Thnx once again.

Regards,

Praveen.

Answers (1)

Answers (1)

former_member220863
Active Contributor
0 Kudos

Dear Amit,

In the status profile select the sent to repair status>New entries>select the Business Transaction

Enter PM processing data Forbidden

regards

sunil

Former Member
0 Kudos

Hi Sunil,

If i am not wrong you are talking about to select the business process which is near the status tab.

But i dont know how to use the same with user status.

AR