on 07-13-2009 10:12 AM
Hi Guys,
I don't understand why during usage decision, system pops up the following message even though I have force the inspection completion on one particular inspection characteristic.
Valuate the non-valuated QM characteristics manually? Yes button and No button
After hits Yes button, another message appears...
Class characteristic QNNVM1 can be manually evaluated.
There are two inspection characteristics in this inspection lot, and one inspectin characteristic has been record as pass and accepted during result recording, while another inspection characteristic (which is a required characteristic on system setup) did not perform result record. Thus, during QA11, I force this required characteristic to inspection completion.
My questin is why the system gave me "Valuate the non-valuated QM characteristics manually?" message?
Thanks
YY
Dear yong
This is normal
Regards
gajesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Gajesh,
So this is normal?
Regards,
YY
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Yong
I think you have attached the characteristic to the required MIC. This is a process by which the class characterisitic is updated in the batch. This happens when the UD is given. that is why you are getting the Pop up message
Regards
Gajesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
95 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.