Skip to Content
avatar image
Former Member

file to file BPM

hello experts

I try to make a simple file to file scenario, using BPM. in the BPM I have a reciever and sender (with out transformation or anything else). I see it in the SXMB enter to the BPM, but no file is coming out.

is it possible to make a simple file to file scenario?

any suggestions?

(I can make the scenario with out BPM/ the reason I am doing it with BPM is to check something).

help is required

Kfir

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

5 Answers

  • Jul 13, 2009 at 07:06 AM

    hi,

    >>>is it possible to make a simple file to file scenario?

    yes

    >>>I see it in the SXMB enter to the BPM, but no file is coming out.

    did you make the config in ID using the wizard twice?

    one from file to BPM

    and one BPM to file ?

    if not do it

    you can also click on PE and see on which step did the BPM stop

    Regards,

    Michal Krawczyk

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jul 13, 2009 at 07:15 AM

    In addition to the aboce also go to SXI_CACHE and check the status code of your BPM process which should not be 99

    HTH

    Rajesh

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jul 13, 2009 at 07:20 AM

    Hi,

    for simple file to file scenario no need of BPM...u can search on sdn for file to file scenario..u will get step by step guide for it.

    Regards,

    Manisha

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jul 13, 2009 at 07:23 AM

    yes I did make both the configuration in ID, on both directions.

    what is PE?

    where can I debug the BPM?

    Kfir

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      In SXMB_MONI just click on the PE link which will be present in the Outbound/ Inbound Column....then click on the Graphic column...this will display the flow of BPM for that particular message processing....Green indicates without any error....Red indicates error....

      If everything is fine here then check for any error log in your receiver File CC.

      Regards,

      Abhishek.

  • avatar image
    Former Member
    Jul 13, 2009 at 07:59 AM
    Add comment
    10|10000 characters needed characters exceeded