Skip to Content
0
Former Member
Jul 10, 2009 at 09:21 PM

Data Integrator Job Failure on R/3 side

22 Views

Hi,

We are implementing the latest version of BusinessObjects Data Integrator (Data Services 12.1). We use it to extract data from SAP R/3. When we run a job using Generate-and-Execute mode in development, it appears as if Data Integrator submits the job to SAP R/3 multiple times. It should be submitted only once. This causes an error in R/3 which produces a short dump that says LOAD_PROGRAM_NOT_FOUND. Has anyone else experienced this problem or have any ideas as to what might be causing this behavior?

Below is some part of the short dump.

Program "ZW62700000" not found.

-


What happened?

-


There are several possible reasons for the error:

or

The current ABAP program had to be terminated because the

ABAP processor detected an internal system error.

The current ABAP program "RSBTCRTE" had to be terminated because the ABAP

processor discovered an invalid system state.

-


What can you do?

-


Print out the error message (using the "Print" function)

and make a note of the actions and input that caused the

error.

To resolve the problem, contact your SAP system administrator.

You can use transaction ST22 (ABAP Dump Analysis) to view and administer

termination messages, especially those beyond their normal deletion

date.

-


Error analysis

-


On account of a branch in the program

(CALL FUNCTION/DIALOG, external PERFORM, SUBMIT)

or a transaction call, another ABAP/4 program

is to be loaded, namely "ZW62700000".

However, program "ZW62700000" does not exist in the library.

Possible reasons:

a) Wrong program name specified in an external PERFORM or

SUBMIT or, when defining a new transaction, a new

dialog module or a new function module.

b) Transport error

b) Transport error

Thank you.

Naveen