Skip to Content
avatar image
Former Member

inspection characteristic and classification in material master

Hi Guys,

Two Questions:

1 - I am wondering when I create the characteristics to be used in the Master inspection characteristics, does these characteristic have to be upload or maintained into the classification view for this material in the material master?

2 - I am asking this because when I went to perform my result recording using QE51N, the screen presented include an inspection lot with two inspection characteristics. One characteristic is reside in the inspection plan, however, the second inspection characteristic does not maintain inside this inspection plan and yet it is present in the result recording as part of the inspection characteristic. This second characteristic is maintain inside the classification view in the material master. May I know why the 2nd inspection characteristic appears in result recording screen even though it is not maintain as part of MIC in the inspection plan?

Regards,

JD

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Best Answer
    avatar image
    Former Member
    Jul 09, 2009 at 02:35 AM

    Hi Sujit,

    Your answer is very helpful.

    However, I have further question which is....can I choose to ignore this inspection characteristic from the material specification during result recording? will this have any side effect? The reason I am checking this is because I find this inspection characteristic is not helpful during result recording for this particular inspection lot.

    Thanks

    YY

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      hi

      Yong

      can I choose to ignore this inspection characteristic from the material specification during result recording? will this have any side effect?

      Yes if some of the char are not useful to you you can alwaz ignore them in RR .& directly take UD

      also in addition to that if all char are not useful to you you can remove task list Indicator from Inspection setup of that material.

      Remeber you can alwz go for UD & stock posting without RR.

      This will not harm.

      Regards

      Sujit

  • avatar image
    Former Member
    Jul 08, 2009 at 10:01 AM

    Hi

    May I know why the 2nd inspection characteristic appears in result recording screen even though it is not maintain as part of MIC in the inspection plan?

    You have selected Material Specification In the QM view along with the Task list.

    So when you go to result recording you will found that a additional char will flow form Material Specs

    this is not from Material Master

    Regards

    Sujit

    Add comment
    10|10000 characters needed characters exceeded