on 07-07-2009 10:59 AM
Hi, colleagues
after implementation of the Note 1358181 within the implementation of Note 1172948 in SolMan 7.0 EHp 1
I am geting contiously Syntax Error in short Dumps for different programms.
That says - DIAGLS_SOFT_COMP_VERS_PATCH_LV is not exist.
Did I something wrong? Or it is a SAP-bugg?
Has somebody els this problem? and what can I do now?
I cannot elliminate the Note 1358181 alone due to dependensis to the Note 1172948
I am very pleased for any construktive help
Best regards
Vladimir
Hi,
to solve this error it is necessary to execute the manual steps described in note 1358181.
Usually they should be done before implementing this note to avoid syntax errors. In this case you just have to execute them now and afterwards your issues will be solved.
You don't have to install note 1358181 again or uninstall it.
Best regards,
Claudia
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
OOOOO!!!!!!
Its terrible!!!
I used this Note everytime in german language !!!!
In german there are NO any thigs about manual actions!
What I can say - It is very stupid to do such a thing
By the way SAP change dependeaces of 1358181 to 1172948 today! So I could deinstall the Note 1358181!
Thank you Claudia very much!!!!
Vladimir
Do you see this SYNTAX_ERROR?
Syntax error in program "CL_SMSYEN_SYSTEM==============CP
The following syntax error occurred in program
| "CL_SMSYEN_SYSTEM==============CP " in include
| "CL_DIAGLS_SOFT_COMP_VERS======CU " in
line 43:
| "Type "DIAGLS_SOFT_COMP_VERS_PATCH_LV" is unknown"
| " "
| " "
| " "
|Information on where terminated
| Termination occurred in the ABAP program "CL_SMSYB_BUFFER_PRODSYS_RELS==CP" -
| in "CLASS_CONSTRUCTOR".
| The main program was "SAPLSMSY_MAIN "
|
| In the source code you have the termination point in line 10
| of the (Include) program "CL_SMSYB_BUFFER_PRODSYS_RELS==CM009".
The SYNTAX_ERROR has been reported by another customer, development is working on the resolution.
Best regards,
Ruediger
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Did you upgrade to SPS 18 or 19?
I had some syntax errors too after upgrading to 18 (EhP1) and implementing the note.
After upgrading to 19 my problems were solved.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
23 | |
11 | |
9 | |
8 | |
5 | |
5 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.