Skip to Content
avatar image
Former Member

UD for Good Issues

Hello,

I am an MM and need some helps for UD for GI, I know SAP standard doesn't recommend this however I have a requirement where if I have a PO against a cost center or an order and when I do the GR I wanted to have the stock posting tab in the manual UD screen, I am not sure what I did in the past but it worked for me then, in SPRO I checked both Qty/value update for the material type still the stock posting doesn't show up.

I am running ECC 6.0

Please help

Ibou

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Jul 06, 2009 at 11:07 PM

    >

    > > I am an MM and need some helps for UD for GI, I know SAP standard doesn't recommend this however I have a requirement where if I have a PO against a cost center or an order and when I do the GR I wanted to have the stock posting tab in the manual UD screen, I am not sure what I did in the past but it worked for me then, in SPRO I checked both Qty/value update for the material type still the stock posting doesn't show up.

    >

    Which inspection type are you using for this purpose.

    If you are using inspection type "02 - GI Inspection" then use I like to update 02 inspection type is not stock relevant.

    Please try to use 01 or 08 to get stock posting tab.

    Hope this helps.

    Thanks!!!

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      hi

      what is the inspection type assigned in material master and what is the movement type ?

      i hope u assigned 02 inspection type,GI inspection is not relavant to QI stock,

      that's why u didn't find sock posting tab

      thanks

      sami

      Edited by: sami sami on Jul 8, 2009 4:15 AM

  • avatar image
    Former Member
    Jul 07, 2009 at 04:58 AM

    Hi

    Try to use any one of these 01,08 and 89 inspection types.

    Thanks

    S.Murali

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Thanks for the information, I used inspection type 8 but still I couldn't post the stock, could you please give me more details.

      Thanks

      Ibou