Full & Init parallel data load to SAP BW using SLT not working

[sridhar_v6]

Hi,

We are trying to load the data from SAP ECC (6.0) system to SAP BW using SLT.

SAP ECC --> SLT --> SAP BW.

We are replicating data from standard tables like MARA. Created 2 flows on the same data source which loads to 2 ADSOs. Once Init load is completed to the 1st ADSO , we tried loading Full DTP to the 2nd ADSO. Thsi load is failing in BW and at in the source MARA trigger is getting deleted.

My question is is it possible to load Init and Full using SLT to the same target system (BW in this case). If yes how to do it.

Thanks

Sridhar

[former_member592302]

Hi Sridhar,

Below is a extract from the SAP NOTE : 1972175.

Restrictions
The initial loading of table content takes place for the first subscriber of a delta queue. During
this initial load, no other requests in the same queue can be processed. Following the initial load,
other subscribers can connect to the same delta queue but can call delta data only. Initial loading
is not possible.

I think this might be causing the issue.