Skip to Content
avatar image
Former Member

Material to material transfer

In which type of scenario material to material transfer is used in transaction code MB1B and mov type 309. Can it be used to transfer the defective material which is repaired to the some other material.

Thanks

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • avatar image
    Former Member
    Jul 02, 2009 at 11:06 AM

    hi VAIBHAV VIRKUD ,

    1)in big companies it may happens that their may be duplicate codes available, so in that codes one material code is blocked and all stock transfered to another material code

    2) If in the same material stock is required to transafer from one batch to another batch, in that case also 309movement type is used.

    If it is useful to you give point .

    Regards,

    yagnesh

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jul 02, 2009 at 10:50 AM

    if you are maintaing more material codes for the same material depending on the stages in procees.

    This is the case of process industries.

    If one material say a machine is break down or repaired.

    Or you are sending one material as scrap, at scrap the material code may differs

    Add comment
    10|10000 characters needed characters exceeded

  • Jul 02, 2009 at 11:12 AM

    Hi,

    Please check the below sap information.

    If a material changes over time in such a way that it no longer corresponds to the features defined in the material master record, but to the features of a different material number, you have to carry out a transfer posting from material to material. This is often the case in the chemical and pharmaceuticals industry, for example.

    Such a transfer posting is always carried out in one step and without advance planning. The posting can only be carried out from the unrestricted-use stock of the issuing material into the unrestricted-use stock of the receiving material.

    Prerequisites

    ● A material master record must already exist for the receiving material.

    ● Both materials must be kept in the same base unit of measure. The basis for all conversions on posting is always the base unit of measure: the unit of entry in the material document is irrelevant.

    Regards,

    Add comment
    10|10000 characters needed characters exceeded

  • Jul 02, 2009 at 11:46 AM

    Hi Vaibhav,

    IF you are maintaining 2 material codes for a material. In that, if you are using one code and not using going to use another code hereafter. You will transfer stock of non usable material code to usable material code in MB1B(309) and you will delete that non usable material.

    Regards,

    Prasath

    Add comment
    10|10000 characters needed characters exceeded