on 11-15-2016 11:52 AM
Dear All.
Web service (SOAP UP) -> HCI -> On premise PI. and i'm using cloud connector to connect my On premise PI.
below are the configuration is done in cloud connector;
created a access control as mentioned below.
and the configuration is
in my receiver SOAP Channel i maintained the address as http://invtofinnest:443/XISOAPAdapter/MessageServlet?senderParty=&senderService=bc_hci_inv&receiverP...
note: I've extracted the wsdl from my pi system and in wsdl target url i've changed as i maintained in could connector(above url) and the same i placed into HCI RECEIVER SOAP channel along with basic authentication.
is that above practice is right?
and when i test the scenario i'm getting an error as mentioned below
please suggest where i did a mistake.
Regards
Ramesh
Hello Ramesh! I hope you are fine! I need to connect my HCP to my IP. Can you help me? How do I do this? Did you rely on any tutorials? Can you show me how?
Thaks a lot.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Good afternoon, Fabio!
I fear I can not help you much or at least not all the way.
I was able to map normally by configuring an http connection on the cloud connector and a destination on the SCP. However, I could not test the connection (if it can, can you tell me how? Rsrs).
Send me an email (cardealt@gmail.com) that I send you the prints of the configurations of both scc and scp destination.
Att,
Cardeal, T.
(Obs: posso presumir que você fala português?)
Changed my target url as http://invtofinnest:443/XISOAPAdapter/MessageServlet?channel=:BC_Invoice:CC_SOAP_SENDER_GET_ISO and it worked..
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
94 | |
11 | |
11 | |
10 | |
9 | |
8 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.