Skip to Content
avatar image
Former Member

Clearing Warehouse Stock

Dear All,

Is there a possibility via WM where we could clear storage unit stock without affecting the IM Stock. I have discrepancies between WM & IM at the moment for a given Sales Order / Line item stock.

Shabeen Buhary

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Jun 25, 2009 at 11:45 PM

    Hello,

    Can you please check the following SAP Note 535043 - Stock comparison with LX23: Difference

    between WM and IM ?

    See if this helps you out.

    Thanks,

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Dear Csaba,

      Thanks a lot for your valuable inputs. Hope i could continue my communications with you with further WM Queries. It was really helpful. (Got any chat id to communicate if you don't mind)

      regards

      Shabeen Buhary

  • avatar image
    Former Member
    Jun 26, 2009 at 05:47 PM

    Hi Shabenn,

    As mentioned earlier by Abhijit, LX23 should be used to reconcile the differences between WM and IM. And LX23 will always adjust IM stock level based on WM stock.

    In your case, if IM stock is correct, you need to:-

    1. Run LX23 to resolve the difference between IM and WM. Now the IM stock level should be the same as WM (although the original IM stock is correct).

    2. Perform a physical inventory to adjust the stock in both WM and IM to be the correct qty. Inventory process should be and can only be perform in WM (LI01N, LI11N, LI20, LI21).

    The stock in IM and WM should be correct now.

    Hope it helps.

    Cheers

    Add comment
    10|10000 characters needed characters exceeded