Any other solutions for solving assessment allocation error during execute?

[Former Member]

Hi,

I am having error message when executing assessment allocation on KSU5 for the first time. I am using ECC 6.0.

The system is giving below message:

System error or customizing error: Read error in set for table CCSS. Message no.: GA622

Diagnosis

Set is used in allocation configuration (table T811X). Set does not exist.

System response.

Processing is terminated since either serious system errors or errors in allocation configuration have occurred.

Procedure

Configuration errors are usually the result of release changes or incomplete client copies. You can eliminate these errors with program RK811XST. Run the program and perform the allocation again. Inform your system administrator if the errors still occurs.

Execute Report RK811XST.

It is also mentioned the same message in SAP NOTES 34087.

However, as far as I know, SAP will audit the system that no one is allowed to execute program in SE38.

So have you had any other suggestions plz?

Need your help asap... Thanking you...

[iklovski]

Hi,

What do you mean 'no one is allowed to execute SE38'??? SE38 is not a 'dirty word', but a transaction to run SAP modules/reports. When you executing a transaction, you eventually can reach the same by executing it from SE38. So, don't be afraid to use this transaction, especially within SAP-recommended solution. You can consult your ABAP/BASIS team, if you are not sure.

Regards,

Eli