Skip to Content
avatar image
Former Member

sost error

Dear All,

I have problem in SMTP configuation, i refered SAP note : 455140, but i could solve some issues like ,

when i try to send message i am getting following error any one plz suggest

Message cannot be transferred to node SMTP due to connection error (final)

Message no. XS816

Diagnosis

Due to a technical fault, the system could not set up a connection to the RFC destination Check port and mail server for SMTP nodes. Therefore, the message could not be transferred to node SMTP.

System Response

The system was unable to transfer the message.

Additional information of the node used (in the system language of the node):

Procedure

Check the connection from SAP system to node SMTP. Perhaps the node is not assigned to the correct RFC destination. If so, correct this in Customizing.

Otherwise use RFC destination management to check the RFC connection to destination Check port and mail server for SMTP nodes.

If R/3 is in productive operation, it is advisable to reroute provisionally to another node.

You should therefore notify your system administrator.

Thanks,

Thirumoorthy.E

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • avatar image
    Former Member
    Jun 24, 2009 at 11:55 AM

    Hi,

    Please check with the values in the SMTP node like the hostname or the ipaddress and the related jobs with SAPCONNECT&ALL. Also check if the default domain is mentioned.

    If you are not using any incoming mail then please uncheck the option for any confirmation of the receipt.

    Also please confirm if you are using internet mail gateway. since the RFC error most arrives in IMGW only.

    Regards,

    Pavan

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jun 24, 2009 at 12:10 PM

    Hi,

    Refer the below notes

    Note 875136 - Node ID is missing in the status message for RFC connection

    Symptom

    The system sends through an RFC node. In the node settings, a time was set for the repeat procedure of the send attempt. In case of an intermittent RFC connection several documents are sent. The first document gets the status text:

    Message cannot currently be transferred to node <node ID> due to connection error.

    With all other documents, the node ID is missing in the status message.

    If the time for the repeating procedure of the send attempt has expired, the first document gets the status text:

    Message cannot be transferred to node <node ID> due to connection error.

    With all other documents, the node ID is also missing in the status message.

    Other terms

    Status, 751, 816

    Add comment
    10|10000 characters needed characters exceeded

  • Jun 24, 2009 at 12:16 PM

    Again, this looks like a problem with the SMTP Relay Agent, Check that the IP Address of your SAP system is populated in the Relay Agent of your SMTP Server.

    Also check that port 25 is open.

    Regards

    Juan

    Add comment
    10|10000 characters needed characters exceeded

  • Jun 24, 2009 at 06:57 PM

    Hi Trimoorthy

    Did you check whether port 25 is open or your SAP sever is added in the ACL(Access Control List ) of your SMTP server? This you can test by simply doing telnet from your SAP Server to SMTP server with port 25 ( Telnet <SMTP_hostname> 25). If you are able to reach your SMTP server then port 25 is open and there is no firewall issue.

    Please also go to SCOT>>SMTP>>Internet>> Check "Adress area" [put a * there]

    From SCOT also check "Settings">> Default Domain

    Please let us know if you still face problem.

    Thanks and Regards

    Anindya

    Add comment
    10|10000 characters needed characters exceeded