Skip to Content
0
Former Member
Jun 23, 2009 at 09:01 PM

SLED, LX02 and LS24

374 Views

Hi everyone,

We are having an problem with the LX02 and LS24 reports. Whenever we cycle count any material, and we run the reports LX02 or LS24, the system does not show the SLED for those items that were cycle counted from 999 (differences) to a good bin even though the SLED exists in MSC3N. However, if we manually change the SLED to anything else in MSC2N, it does start appearing in LX02 and LS24. Can anyone tell me where this setting may lie or alternatively, why this should be happening - if there is any master data correction that needs to be done in the WM views or in the QM views or anywhere else?

Many thanks.