Skip to Content
avatar image
Former Member

MSDS- Report

Dear all,

I am creating substance with all relevant characteristics values. But in mu MSDS report, these characteristic values are not appearing. Report with all other information is available except characteristic values. What may be the reason?

Further during CG 54 i am getting error "The report does not conatin parameter symbols"

Regards,

Rajaram.K

Edited by: rajaram kulkarni on Jun 23, 2009 10:14 AM

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    Jun 23, 2009 at 03:18 PM

    Hi,

    kindly check report symbols(parameter) are generated for particular characteristics which you are using in in MSDS.

    Regards

    Abhijit A. Pachgade

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Yes. But after releasing the template in CG 56 I am getting message " The report does not contain parameter symbols" What may be reason ?

      Regards,

      Raj.k

  • avatar image
    Former Member
    Jun 25, 2009 at 01:50 AM

    hi, you can try to do something below:

    first, you check your symbols that you need in your configuration : .../report symbols/check and specify report symbols, if there are not, you need to creat them,but before this work, you need know if the system has related characteristics and classes.

    then you need to match these data by t-code CGCZ.

    good luck.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jun 30, 2009 at 12:45 PM

    Hi,

    If this error is not apperaing in atleast one system (generaly in DEV system), then you need to matchup the masterdata (CGCZ) in other systems too; if its happening in all your systems, then check something wrong in the template.

    Regards,

    Keshav

    Add comment
    10|10000 characters needed characters exceeded