Auto Update of measuring point/document

[Former Member]

Dear all,

I have one issue over here.Measuring point/document is not updating automatically after productiuon order confirmation . I tried with following steps

1) Created the equipment as test equipment -->created measuring point as a counter ---> maintain the usage value formula SAPF02 in the PRT tab . Unit of measurement for the characteristics and base unit of measure of material are same

2) Then i have assigned this eqipment as a PRT in the routing of material .

Which steps i am missing

Thanks

[former_member187991]

hi

in the production order ,operation overview whether can you able to see the PRT assigned with the measuring point and the formula ,also check in which unit you are cofirming the production order ,it should be same as characteristic you have used

regards

thyagarajan

[Former Member]

Hi Thygrajan ,

Thanks for fast reply

I have checked both parameters . I can see the PRT assigned to the measuring document in production order operation overview and also the unit of measurement is same

Thanks

[former_member187991]

hi

Kindly create one equipment with category PRT (P) and then do the routing steps and check

regards

thyagarajan

[Former Member]

Hi Thyagrajan,

My equipment category is already is P . Secondly When i see the prt usage by Tcode CF23 i can see the usage actual .But still my measuring document/counter is not updating

Thanks

Amol

[Former Member]

Hi

I had faced the same problem when I used SAPF02 then I did following changes.

Created formula like SAP_09 * PRTSTD / SAP_08

SAP_09 : Operation Qty

PRTSTD : PRT Standard Value

SAP_08: Base Qty.

Also make sure the measuring point category should me T in IK02( PRT life counter)

Regards,

Raj