on 06-17-2009 8:17 AM
Hi Gurus,
I have activated rework order through trigger point at the time CO11n Confirm. But the trigger point is trigger even if I enter Yield Qty in CO11N.
Example:
I have Material FERT with with two operation in routing.
I create Prod. Oredre with Qty15. the Order no: 90062.
At the time Order (90062) confirmation i enter the 5no in Yield column and while saving the transaction system will trigger the Rework order.
MY Requirement is if I enter the QTY in Yield coloumn. Trigger point should not trigger.
If i enter Rework qty then trigger point has to trigger the rework order.
KIndly any one give soluntion.
Thanks in Advance.
Regards,
S.Babusingh
Babu,
It's a normal behaviour of the system.
To overcome this you can think of user exits available in CO11N which are listed below.
CONFPP01 PP order conf.: Determine customer specific default values
CONFPP02 PP order conf.: Customer specific input checks 1
CONFPP03 PP order conf.: Cust. specific check after op. selection
CONFPP04 PP order conf.: Customer specific input checks 2
CONFPP05 PP order conf.: Customer specific enhancements when saving
CONFPP06 PP Order Confirmations: Actual Data Transfer
CONFPP07 Single Screen Entry: Inclusion of User-Defined Subscreens
Hope this helps you.
SmanS
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Activate function 2 - also first time trigger the Rework order.
But my problem solved : Using Activate function 1- only Manual trigger point.
Regards,
S.Babusingh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi stupid,
rework question. And give me them points.
Moron!
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
107 | |
12 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.