Skip to Content
0
Former Member
Jun 16, 2009 at 09:30 PM

Inspection Type - Default Values - Inspection for HU

176 Views

Hi Gurus:

In SPRO >QM > QI > Insp. Lot Creation > Define Default Values for Inspection Type

I am trying to check the Inspection for HU box under the Inspection Lot Creation section. It checks fine, but when I save, the check disappears. I have others where I have set this, so I am unsure why it is not letting me. There is no error message appearing...Only the check disappears upon Save.

Thanks for your help in advance.

Nic