Skip to Content
0
Jun 16, 2009 at 08:36 AM

Message after PCain-Step

24 Views

Hi specialists,

the process-chain-management makes it possible to send a message after each process-chain-step.

It is possible to send different messagess depending on the RC of the step.

I expected that the configured message is to be sent to the user exactly as I defined it, but I noticed that the msg-body seems to be ignored completely and instead a lot of technical information (=the protocol of the process-chain) is send.

Is there a way to configure the mentioned function in a way that my configured body is sent instead of the log? Or am I forced to use a abap-program to send my message, instead of the "send message after process-step" ?!

Best regards,

Marco

Edited by: Marco Simon on Jun 16, 2009 10:37 AM