Skip to Content
0
Former Member
Jun 07, 2009 at 02:49 PM

Message control tab is not present in partner profile

99 Views

Hi experts,

I have a requirement where I need to add a new segment to a custom idoc . I am doing this according to the following steps:-

1. In WE31, I have created a new segment and released it.

2. In WE30, I have added the new segment to the idoc and released it.

3. In WE82, I have assigned the Message type to the custom idoc type. Though this is a custom idoc, I am using a standard message type CRMXIF_PARTNER_SAVE_M.

4. In WE41, I have created a new process code ZBUPA and assigned the message type to it.Also I have created a custom function module for outbound processing Z_IDOC_OUTPUT_CRMXIF_PARTNER_S.

5. In WE20, I have created a partner profile and assigned the message type and the basic idoc type in the Outbound parameters tab.

However, I am not getting the 'Message Control' tab from where I can assign the application type to the process code.

For this Idoc, the sender system is CRM and the receiver is XI. Also I am working in CRM6.0 environment.

Please let me know how to go about this.

Thanks,

Samrat.