Skip to Content
avatar image
Former Member

W1 1 traces are active!

We are currently running MaxDB 7.7.04.29 on Red Hat Linux 5.1 for our BW instance.

The output of DBAN.prt gives me "W1 traces are active!" message.

I looked at the Database Trace settings via tx: DB50 and they all say trace is switched off.

I also reviewed OSS Note 837385 under item 11, to deactivate.

Any ideas ?

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

1 Answer

  • Jun 10, 2009 at 07:43 AM

    Hi,

    can you please show us the output of the following DBMCLI command:

    dbmcli -d <DBSID> -u <dbm-user>,<pw> info STATE -d

    Regards,

    Roland

    Add comment
    10|10000 characters needed characters exceeded

    • Hi,

      well, the first DBAnalyzer interval ('0') collects general information of the db instance and will also display whether the database trace is active. This first interval is triggered either daily or whenever the DBAnalyzer is restarted.

      The most obvious reason would be that the database trace was still active during the DBAnalyzer collection of interal 0 on that specific day. After you switched off the trace, only the subsequent interval 0 will not show the message again (that the trace is active).

      Regards,

      Roland