cancel
Showing results for 
Search instead for 
Did you mean: 

Only 1 Instance show up on Maintenance Optimizer Transaction

Former Member
0 Kudos

Dear all,

I got another issue relate to Maintenance Optimizer transaction under dswc, I have 2 satellite systems under 1 logical component.

On the first step of MO transaction , I select Product Version SAP ECC 6.0, there is only 1 system appear, in fact in my logical component there are 2 systems ( in SP Stack screen both systems appear normally)

Anyone know the cause, or there is any further set to be done ? Thanks...

Edited by: sketcher on Jun 3, 2009 3:02 PM

Edited by: sketcher on Jun 3, 2009 5:21 PM

Accepted Solutions (0)

Answers (2)

Answers (2)

Former Member
0 Kudos

Hi Sketcher,

In MOpz, you are selecting the product version ECC 6.0

check once if both those remote systems are difined as ECC 6.0 in SMSY or any other product version ? Second system might be defined of type ERP

and, are you able to see all the systems as 'green' in SMSY -> Solution landscape -> select that particular solution and see if the systems assigned are green or not. Also, by selecting the particular system in the same screen, once check include/exclude button and check consistency then.

and, Are you able to see EWA service sessions for both of those systems in that particular solution view ?

Try to go through these Notes

Note 1020789 - Maintenance Optimizer: Allow all systems to be selected

and if the problem is related to the product version, then you should change the product version to the type of ERP instead of ECC 6, I forgot the exact note number for this, but you can try the below one for this

Note 1022072 - Maintenance Optimizer: "No Data Available" message

Former Member
0 Kudos

Hi Garima,

Both system seems appear find in Early watch, and all green in system group tab. So its only the issue with MOPZ, not with others.

Its a problem with ST higher than 15 (15 - 17), so I just need to implement 1247550. Thanks.

Former Member
0 Kudos

Sketcher

I hope you are trying to MOpz transaction in the correct solution you want and you have already assigned that logical component (to which those two SAP systems are assigned) to this solution.

If all SMSY settings as said above are complete, then I guess this is only the problem with the filter settings in the initial screen on MOpz transaction. In the initial screen of maintenance optimizer screen, there must be a filter button in the right corner, press this filter button and check whether the list comes to choose different filters and whether you can set the filter to show 'all the systems in this solution'.

Former Member
0 Kudos

Hi Garima,

I've done all necessary SMSY setting, assign system to logical component and logical component to my solution.

In initial screen of mopz the filter value already set to all, still I only can see 1 system....

Regards,...