on 06-01-2009 9:35 AM
Hi,
Currently i have just setup a printer in SAP successfully.
But as this printer is a color laser printer, the printouts are in colors.
Is there any settings which i can set it to monochrome?
Thanks
Hello,
Did you checked the settings of the local printer. I believe the SAP printer invokes the local printers and the setting therfore needs to be maintained there .
Thanks
Shubham
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
From any screen in SAP click on System. In the System menu, hover on User Profile and then click Own Data. On the Main User Profile screen, click the Defaults tab. In the Spool Control Section: For Output Device, type: LOCL Print Immediately: Check this.
Hope This Works,
Peter
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
SAP Printer setup for Color Laser printer is not a difficult task for the users sometimes it creating some technical error but it solves quickly without any problem if you are facing some problems like this you must visit our website form complete information print a test page
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Please follow the below steps
Go to Tcode : SPAD
Enter your printer name in Output Devices and click Display
Go to Output Attributes Tab
Check the section Output Attributes for list drivers and Smart Forms
There is one check box "Colour Printer". Just uncheck that selection.
Click on Save button to save the changes.
Check printing from SAP on the printer and confirm.
with regards,
Parin Hariyani
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You might want to take a look at SAP Note 1036961 and review "New Device Type Selection Method in Trasaction SPAD", Document Version 1.50, Dated July 22, 2009. Once you have confirmed table TSPOPIP was updated the the Device type specific for your Color Laser Printer will have new "attributes". These attribuets need to be enabled under the Output Attributes Tab for the priner you are working with.
Regards,
Dan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
85 | |
10 | |
10 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.