Skip to Content
author's profile photo Former Member
Former Member

Decimal places for SKF in KP46

Hi All,

In assessment cycle i am using the SKF to do the allocaiton and the allocation is based on %. But while posting the percentage value in KP46, the value cannot be maintained in decimals. System by default rounding off. When i am maintain the value is 2.45% system automatically taking it as 2% how to rectify this???

Kindly advice

Thanks

Vasantha

Add comment
10|10000 characters needed characters exceeded

2 Answers

  • author's profile photo Former Member
    Former Member
    Posted on May 25, 2009 at 04:14 AM

    HI Devaraj,

    Check your settings in the Planning Layout you are using for SKF Planning. In the Planning Layout, you can set the Number format and No. of Decimal Places.

    And also check the Unit of Measurement decimal places settings in the Config.

    Revert back if you need further assistance...

    Srikanth Munnaluri

    Add comment
    10|10000 characters needed characters exceeded

  • Posted on May 25, 2009 at 04:15 AM

    HI,

    In SKF, you would have used some Unit of Measure. In the transactio CUNI, you can find the decimal places for the same UOM and that would have been ZERO.

    Vijay

    Add comment
    10|10000 characters needed characters exceeded