Skip to Content
0
Former Member
May 21, 2009 at 10:26 PM

Refresh Parameters

101 Views

Hi ,

I create parameter fields and use select expert by record to link it to the data , when i run the report in the preview mode it prompts fine i choose the needed and say Ok.

now the results dont change, only when I click the apply 'tick' the settings that I chose are applied to the data set and its filtered and the results are seen.

all this works very fine , my question : Is there a way to automatically show the results when a parameter is chosen, and Ok is clicked , rather than do all this and then finally apply it.

Also I know that parameter fields work when used with ODC in CRDC , will this be the same case there too?

Thanks for you time in reading my question.