SNP PDS transfer ends up with error - No single or multiple resource

[Former Member]

Hi,

I am transferring SNP PDS data using CIF, it ends up with error in inbound SCM with message as follows:

@5C\QError@ No single or multiple resources can be used in SNP PDS

Has anybody faced this error? Any idea what I could be missing.

I tried transferring SNP PDS data for other location and it worked fine.

Thanks

Sharad

[Former Member]

Hi Sharad,

Please check the resource type of the resources , as your current message says no single or multiple resources can be used in SNP PDS, if resource type is wrong, correct it and then cif again

Regards

R. Senthil Mareeswaran.

[Former Member]

Dear Sharad,

Are you using suboperation or seconday resource in recipe as its not supported in SNP PDS because SNP PDS considers only linear chain of activities.

Also, alternative modes for the PDS can either be created using alternative sequences or resource classification but not both.

Please check the same.

Best regards,

Vaibhav

[Former Member]

Hi,

Before transferring pds please ensure you have transfered plant, material, work centre properly.

Your resource must be bucket resource for snp.

Thanks,

Satyajit.

[Former Member]

Satyajit, I already have PPDS PDS created for the product, so location, resource, products are not an issue.

Also resource is single mixed resource...so logically SNP PDS should get created.

Did you ever get message which I have talked about.