Inventory data verification BW vs R/3

[former_member522325]

Hi Experts,

I'm working in support projects, my user raised issue on inventory report is tie with R/3 report.

please make note, my inventory report based on standard Inventory infocube 0IC_C03.

When I generate report by plant for the valueated stock qty, valueated stock value, compare to R/3 mc.5 t.code the final figure is not tie with R/3 system.

Can anybody suggest where could be problem and how to investigate.

SRI

[Former Member · Accepted solution]

Hello Siri;

Usually I make the comparison in MB51 but I have very carefull with movement types.

In this transaction entries comes with + value and outs with -.

In BI all documents comes with +. - are the reversals.

Regards;

Ricardo

[Former Member · Accepted solution]

Hello Guys,

Is there a way to find Standard BI reports that are similar to SAP standard report?

Eg : Standard SAP reports MC.9 and MB5W

What will be the equivalent SAP BI report?

Thanks

Mohan

[Former Member · Accepted solution]

Hi,

Try comparing with MB5B and see if you can match all the data or not. If you are not able to match data then post your observations here..

SA

[Former Member · Accepted solution]

Thanks Sorabh for your reply.

My question was

Is there a way to find corresponding standard repots from SAP like MC.9 and MB5B reports in BI?

Thanks

Mohan

[former_member522325]

Thanks for your everyone.

I have managed to check with MB51. Now my inventary report is matching with R/3.

I have assiged points. thanks.

[ssurampally]

hi,

Some time you may not match the inventory data with MC.5(detailed data). Firstly you can Reconcile with MB5b and MMBE, if the stock values are correct with BW. Then no data issue. If this is not matching then you can look into the compression of non cum key figures.

[former_member522325]

thank you for your reply.

I have not performed compression yet.

I'm using only BF & UM.