Sysfail status in SMQ1

[former_member335553]

Hi

I have sysfail error in tRFC and qRFC (SM58 and SMQ1) Error message with function module not found and exception raised .Scenario is from ECC-XI-Third party system.

Checked for dumps in SAP XI where in I could get the following message " Error in ABAP Program "SAPMSSY1"and the program is terminated Probably due to an error in program .this is a standard Program and moreover this interface has run successful till april end

Please let me know your suggestions to clear off the sysfail status

[Former Member]

Hi

check the reply of Rob at this thread regarding error with SAPMSSY1 program

Regards

Abhishek

[former_member335553]

Hi

Bringing it to the top .Still unresolved

The error popped up after support pack installation .What all entries I need to check over for this RFC scenario to presume .

SM59 working fine

Please post your views

[former_member335553]

Hi

Bringing it to the top .Still unresolved

The error popped up after support pack installation .What all entries I need to check over for this RFC scenario to presume .

SM59 working fine

Please post your views

[former_member335553]

Any ideas on this ?

[Former Member]

Anusha

Can you provide more log detail?

Please check the qRFC log from SMQ1?

PJ

[former_member183908]

Hi

-->Refer this it explains how to resolve the SYSFAIL issue.

/people/sap.user72/blog/2005/11/29/xi-how-to-re-process-failed-xi-messages-automatically

Thanks

[Former Member]

Anusha

Can you provide more log detail?

Have you also check the qRFC log from SMQ1?

Hope this help.

PJ

[Former Member]

Can you write the text message of the dump?