on 04-30-2009 2:07 PM
How can I exclude data as part of a load as part of an infopackage selection? Thanks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
You must create intervals without the value to exclude.
Regards,
Alex
I want to avoid this since the values which are to be included are dynamic and the range may change. All we know for certain which will not change is the values that we would like to exclude. Thanks
Then you can go for ABAP routine for that particular field in the infopackage and write the necessary logic to maintain dynamism.
Thanks. We have written ABAP for selection based on a lookup. However, can you actually write for exclusion of a few values
in the routine?
Niten,
You can exclude few values from an InfoPackage by writing a routine, basically if its a range.
Mansi
Thanks. It is not a range it is two values
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.