Skip to Content

How to configure 349 Movement for stock where QM is active for material ?

Hi Case is as below

1. with 341 movement some stock moved to Blocked stock.

2. 08 , 01 , 09 inspection setup are active for material.

3. Current Scenario is i am doing Block to Unrestricted and then unrestricted to Quality Stock movement to get inspection lot for material handling Unit (VLMOVE or MB1B transaction)

4. Requirement : I want directly to move stock to QI from Block using 349 or other transaction.

5. but when i am trying to do 349 movement using MIGO/MB1B / VLMOVE i am getting one error only as below

Change the inspection stock of material XXXXX22 in QM only

Message no. QA495.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Aug 10, 2018 at 02:53 PM

    Dear Varinder Verma,

    thank you for the details provided.

    Error QA495 is raised most of the time to avoid creating stock inconsistencies in the system.

    I think your case is following:

    The affected material has an active stock relevant inspection type (01 or 09). To movement type 349 (for each "variant") lot origin 08 is assigned. (It can be checked in transaction OMJJ --> Movement type --> tab 'Update control / WM movement types' --> Details.) When you try to post the stock with MIGO (or MB1B) with movement type 349 for this material, system expects a lot origin 08 to be created, which cannot happen according to your current configuration. Therefore, error QA495 is raised properly to avoid any stock inconsistency. Message text also says:

    "... You want to make a stock posting to/from the inspection stock. This is not allowed for material xyz because the quality inspection control has been activated by QM. The following cases can occur:

    • The inspection stock should be increased, although an inspection is not foreseen for the current goods movement ..."

    To avoid QA495 your configuration needs to be adjusted. It is not possible (or recommended) to bypass this error message to keep the system consistent.

    Summarized:
    What might cause QA495 in your case is that inspection types 01 and/or 09 are stock relevant, while indicator 'Insp. for HU' is active for the inspection type 08 in the material master. Therefore, the 08 lot would be created at packing of the delivery, not during the stock posting.


    Have a nice day,

    Albert

    ***

    Read and follow the 'SAP Community Rules of Engagement' at

    https://www.sap.com/community/about/rules-of-engagement.html

    Add comment
    10|10000 characters needed characters exceeded