Skip to Content
0
Former Member
Apr 25, 2009 at 06:23 AM

inspection point reg

84 Views

Hai girus,

I had made settings for the inspection point as follows:

1) Go to CA02

2) go to header

3) Maintain inspection Point as 150

4) Maintain partial Lot Assign as partial lot assignment according to plant default

5) At Operation level maintain a QM work center ( testing ) with Control key QM04 ( as per your requirement)

6) double click on the control key and go to Quality Management : Inspection points

7) Maintain Inspection point completion : Quantity , Valuation and confirmation.

8) choose time related and keep Tfac 1 and Unit as HR ( As needed)

9) You can select quantity - related also and then maintain the quantity.

10) Selection the QM operation and maintain in the MIC with sampling procedure

i had maintained the sample size as 1in T.C = QDV1.

My question is when I tried to do result recording using T.C = QA32 a pop up screen for inspection point

is created but I am unable to record any data as I am getting only single line for result recording which

we get during normal result recording for QA lot .

How to get sequence of result recording for a particular inspection point as I had mentioned Time factor

as 1 Hr , so I should record 7 results for the inspection point that is for every one hour in a shift( 8 hrs in a shift)

waiting for the positive reply.

with regards,

sekar chand