Skip to Content
0
Former Member
Apr 23, 2009 at 12:39 PM

Inspection type problem

874 Views

Hi Sap Gurus,

I copied 01 inspection type to Z013 inspection type and followed the following procedure. But while posting MIGO inspection lot is not getting created and stock is updating in unresticted use stock. But same material with 01 inspection type inspection lot is getting created. I donot know where i did the mistake. Is there any setting in MM of this?

Procedure followed:

1) Assigned inspection type in material master with active key

In customization I maintained the following procedure

1) Maintain task list usage - SPRO> QM> Quality Planning > Inspection Planning> General> Define task list usages

2) Maintain inspection type - SPRO> QM> Quality Inspection > Inspection Lot Processing > Inspection Lot Creation > Maintain inspection types (for eg Z013) - maintain the task list usage here

3) Maintain Quality inspection lot origins and assign inspection types - SPRO> QM > Inspection Lot Processing > Inspection Lot Creation > Maintain inspection lot origins and assign inspection types

4) Define default values for inspection type - SPRO > QM> Quality Inspection > Inspection Lot Processing > Inspection Lot Creation > Define default values for inspection type

Regards

Krishna