Skip to Content

Valuation mode - multiple limits

Hi experts,

I have the following scenario:

Sampling procedure used:

Sampling type = Fixed sample

Valuation mode = Attributive inspection nonconf. units

Determination rule = Fixed sample

Inspection points = Free inspection pts

Sample size = 5

Acceptance number = 1

Inspection frequency = 1

In Inspection Plan, the quantitative Inspection Characteristic have Upper limit = 500.

Results confirmation = Single result and Required char.

So, that still permits 1 nonconforming units or defects in a sample acceptance of the inspection lot.

However, this out-of-specification result could not be greater than 2000, otherwise, the inspection lot should be rejected.

Is it possible to configure this?

Thanks

Regards

ED

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

1 Answer

  • Best Answer
    Jul 27, 2018 at 01:23 PM

    I don't think that is possible.

    You have to write your own function mode to do the valuation and config that in as a new valuation mode.

    Craig

    Add comment
    10|10000 characters needed characters exceeded