on 07-27-2018 1:37 PM
Hi experts,
I have the following scenario:
Sampling procedure used:
Sampling type = Fixed sample
Valuation mode = Attributive inspection nonconf. units
Determination rule = Fixed sample
Inspection points = Free inspection pts
Sample size = 5
Acceptance number = 1
Inspection frequency = 1
In Inspection Plan, the quantitative Inspection Characteristic have Upper limit = 500.
Results confirmation = Single result and Required char.
So, that still permits 1 nonconforming units or defects in a sample acceptance of the inspection lot.
However, this out-of-specification result could not be greater than 2000, otherwise, the inspection lot should be rejected.
Is it possible to configure this?
Thanks
Regards
ED
I don't think that is possible.
You have to write your own function mode to do the valuation and config that in as a new valuation mode.
Craig
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
107 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.