Skip to Content
avatar image
Former Member

Inprocess inspection

Hii

I've assigned time based inprocess inspection with interval of 4 Hrs. The results recording screen shows: Next inspection (shortest Interval 4 Hrs).

What settings needs to be done for automatic generation of inspection points till the scheduled finish date of the order, based on the first entry i do in results recording?

i.e. suppose i do first entry at 12.00 pm, the system should generate inspection points every four hours automatically from 12.00 pm onwards.

Kindly help.

Regards

Prahlad

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

5 Answers

  • Apr 15, 2009 at 10:51 AM

    hello Prahlad

    1) Go to CA02

    2) Go to operation overview - double click on the control key for QM operation

    3) Scroll down to get Quality management - Inspection point

    4) maintain tick on Time related and T fac = 4, Hr.

    Inspection point will get generated automaticaly

    Regards

    gajesh

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi Prahlad

      your requirement is

      i need automatic generation , i.e. the system should generate points each 4 hrs....

      if I am not wrong It sounds that you want seperate inspection lot after every 4 hrs

      but when you give inspection point, then in that case you can use same inspection lot and keep recording after every 4 hour till you want and finally when your result recording is over give usage decision.

      please revert back for any doubt

      Thanks

      Vinay

  • Apr 15, 2009 at 11:23 AM

    Dear Prahal

    please check in Config you have maintain Function module for the inspection point

    SPRO>QM>Quality planning> Inspection planning> General> Define identifier for inspection point> inspection point > Function module tab> maintain >QAPP_CUST_IP_CREATE and tick on Fucntion module. this is for Automatic Creation of Inspection Points and P

    regards

    gajesh

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi Prahlad,

      The system will not prompt with next inspection point. Instead you need to give a new inspection point eg. 4hr, 8 hr etc in your case and record the results. So, everytime you record the results, you need to give different inspection point.

      Regards,

      Keerthi.

  • Apr 15, 2009 at 12:36 PM

    dear Prahlad

    I think there is a time limit for creation of inspection point. As you have maintained 4 hrs it will take min some time for the same it seems. I request you to test with 5 mins. if this works 4 hrs should work

    Regards

    gajesh

    Add comment
    10|10000 characters needed characters exceeded

  • Apr 15, 2009 at 01:28 PM

    Dear Prahlad

    What is the inspection point that you are using. Make use of 150 inspection point. Create a new lot and check the same

    Regards

    gajesh

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Dear gajesh

      I'm using 150 as mentioned earlier.. The query is how do i get to see the time of next inspection based on the number of hours mentioned in the master.

      Thanks

      Prahlad

  • Apr 16, 2009 at 03:39 PM

    Dear Prahlad

    You will normaly get the inspection point detail in the POP up when you click in Assigned Inspection point.

    Regards

    Gajesh

    Add comment
    10|10000 characters needed characters exceeded