Skip to Content
avatar image
Former Member

eRWB end to end monitor configuration error

Error msg:

 
Configuration saved RFC ping failed for the following RFC destinations (created upon saving) in the system PI0001: PMIMZ020020090413 

Incorrect RFC Destinations: When the configuration is saved, an RFC destination is created on the monitoring server for each XI component to enable end-to-end monitoring of the respective XI component. However, the test call failed for the destinations listed. Therefore, you must check the call and the authorization on the monitoring server for the destinations concerned, by using transaction SM59. Also check whether RFC user used for the destination is maintained in the relevant XI component. Note that a component can only be monitored when its RFC destination is maintained correctly.
Incorrect RFC Destinations 
 
Component Type Name of Component RFC Destination Message for RFC Call 
ALE-LogicalSystem MZ0CLNT200 PMIMZ020020090413 Error when opening an RFC connection 

When I check the RFC destination, I found XI createPMI destination with Load balancing Status "YES" every time, and failed the connect test.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • avatar image
    Former Member
    Apr 13, 2009 at 04:43 AM

    Hi Shen,

    I faced this error just a few days back and the solution is that you have to concentrate on the system that is being mentioned in the error that you have pasted. Check the details log on testing of the connection in sm59

    Secondly, check that pirwbuser is getting locked or not , the password of this user used be same in the calling and called system.

    Regards

    joel

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Apr 13, 2009 at 04:59 AM

    Hi,

    Please check the RFC's PMIMZ020020090413 in SM59.

    There you will find the test conncetion tab. Please check if you are able to login to target system or not.

    If not please set the logon parameters and host name.

    Also if the name and password are correct, check the following points

    1. The user is not locked on system that is the target of the RFC.

    2. Assigned the Authorisation object S_RFCACL for the user. It is to allow the user to access the trusted/trusting system.

    3. If you are on PI7.1 please check if the sm59 destination has fully qualified hostname.

    I hope it should solve your problem.

    Best Regards

    Jitender Chauhan.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Apr 13, 2009 at 06:18 AM

    SM59, connection test error:

    Error Details ERROR: service 'sapmsMZ0' unknown

    Error Details DETAIL: NiPGetServByName: service 'sapmsMZ0' not found

    User is not locked.

    I think the RFC connection is not created correctly.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Apr 13, 2009 at 07:06 AM

    Hi,

    Can you check the service Name 'sapmsMZ0' in your services File? If not you have to add 'sapmsMZ0' in your file named 'service' in your server side.

    Also have a look on the following sap note

    [https://websmp130.sap-ag.de/sap(bD1lbiZjPTAwMQ==)/bc/bsp/spn/sapnotes/index2.htm?numm=882741]

    Regards,

    Jitender Chauhan

    Add comment
    10|10000 characters needed characters exceeded