DTP Delta not working

[Former Member]

Hi All,

I have a strange problem in our APO BW system. I have two delta DTPs which loads data from DSO A to Cube B. These two DTPs were having different filters. These two DTPs were sheduled to load parallel. Its working fine. The problem is if these DTPs are executed in a time, when there is no new data in source DSO A. It will fetch the FULL data from the source. Delta is not working at this time. Could any body faced such a situation? Could any body give me a light on this issue.

Thanks in advance,

Binoy

[Former Member]

Hi Binoy

When there is no new data in the source DSO,it should not extract any records and it should extract only 0 records when you run the delta DTP.

Can you let me know what are the settings you have been done in the DTP like( get delta at once or by request by request)

And also check if there is any Full DTP.

Regards

Jagadish

[Former Member]

Hi Jagadish,

Thanks for the response.

Settings are

get delta once - not set

request by request - not set

delta from change log .. delta init from active table option is seletected.

There is a FULL DTP which is not used for datal oading.

Regards,

Binoy