Skip to Content
avatar image
Former Member

Problem in Creating Receiver Agreement

Hi,

I had created a namespace in IR and did a simple idoc to file scenario.

In the IR, the MI and MT are not been shown while creating the receiver agreement and receiver determination.

Do let me know what would have been wrong.

I tried entering it manually and it gave error like schema not recognized.

Regards

Krish

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    Mar 31, 2009 at 08:35 AM

    go to business system/service and add the entry in respective tab afterwards it will show .

    Rajesh

    Add comment
    10|10000 characters needed characters exceeded

  • Mar 31, 2009 at 08:39 AM

    Did you use a Business system or a business service?

    In case it is a business service you will have to manually open the B Service and add the interfaces to the business service.

    In case you are using a business system, then try to refresh your cache and then check if they show up.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Mar 31, 2009 at 08:35 AM

    Hi,

    when u r Doing Idoc to file scenario, sender side u have to use a ABAP business sysytem.

    hope u have imported the same in configuration scenario.

    in that u have to select u r MI. then onlly it will reflect in the Reciver Determination

    Regards,

    Madhav

    Note: Points If Useful.

    Add comment
    10|10000 characters needed characters exceeded