Maintain the Route Permission Table in the system32 for saprouter

[Former Member]

Hi friends,

I am establishing a remote connection to SAP

1) I have installed saprouter in Windows, saprouter service created successfully

2) I followed the link http://help.sap.com/saphelp_nw70/helpdata/en/4f/992dab446d11d189700000e8322d00/content.htm and according did all configurations

3) Now I don't know how to create and maintain Rout Permission Table in system 32

The following example I got from help.sap.com

156.56..

All host addresses beginning with 156.56

133.27.17.*

All host addresses beginning with 133.27.17

133.27.16.0/24

All host addresses beginning with 133.27.16 (0/24 at the end means that the first 24 bits are relevant, that is, the first three blocks)

156.56.1011xxxx.*

All host addresses from 156.56.176.* to 156.56.191.*.

(Binary interpretation of the third byte of the address. u2018xu2019 is a freely selectable binary value (1 or 0).)

I found complex in above note:

My router IP is 192.168.1.116

Kindly guide me for further help.

Regards

Nilanchal

[Former Member]

Hi swara,

checks this

http://help.sap.com/saphelp_nw70/helpdata/en/4f/992dfe446d11d189700000e8322d00/content.htm

http://www.easymarketplace.de/saprouter.php

http://www.sap-img.com/bc048.htm

Cheers

Deepanshu

[Former Member]

Nilanchal,

Check out the following links:

[http://help.sap.com/saphelp_45b/helpdata/en/4f/992dab446d11d189700000e8322d00/frameset.htm]

You can check route permission table link in the above link.

Have you posted real IP addresses? if yes, please do not post real IP addresses on the forum for your network security reasons.

Also check following Note:

Note 525751 - Installation of the SNC SAPRouter as NT Service

Hope this helps.

Manoj

Edited by: Manoj Chintawar on Mar 30, 2009 12:34 PM