Skip to Content
Mar 24, 2009 at 11:48 AM

Calibration Order...Test Equipment


Hello Sir,

Here i m creating one calibration order with type PM05.Inspection type 14 is assigned to same order type.

Now i am creating 1 maint order for equipment which is category Q.I created taks list with inspection point 300 for the same and also assigned MIC for that.

I am stuck up in that.It is created inspection lot but from this point i am not able to process further.

Sytem is showing following massage...

*Usage decision data for inspection lot cannot be displayed

*Message no. QV100


A sample has not yet been determined for the inspection lot. It is therefore not possible to display the usage decision data for the inspection lot.


Use the function to display an inspection lot.

Awaiting for replay..

Thanks and regards,

Pravin Chougule