Skip to Content
0
Former Member
Mar 22, 2009 at 06:18 PM

EHP4 Upgrade: OCS package "SAPK-110EXINMED" does not match SW component

28 Views

Hi!

I would like to upgrade SAP ERP 6.0 to EhP4.

During the phase PREP_EXTENSION/ADDON_QCALC (Configuration) I was asked regarding the procedure of 2 Add ons: ST A/PI and MED.

I answered the question that I would like to update the components with SAINT.

During the Add on queue calculation by tool I get the following error:

OCS package SAPK-110EXINMED does not match the current software component

3 ETN256 You want to install the following add-on components:

3 ETN248 Component: "MED" rel. "110_600", Support Package level: "0" (component type "C")

2 ETN085X"2. Adding Add-on Installation Queue" " " " " " "

3 ETN262 Calculating queue part for add-on "MED" rel. "110_600"

3 ETN490 Use the Add-On installation package "SAPK-110CHINMED" (type &4"AOU") for Add-On &2"MED" rel.&3"110_600"

3 ETN245 The following import prerequisites of OCS Package "SAPK-110CHINMED" have not been met:

3 ETN264 In the (alternatively) Requirement set "01":

3WETN492 Required Add-On component "IS-H" rel."600" is not installed

3WETN491 Required software component "SAP_APPL" rel."600" is not installed

3 ETN490 Use the Add-On installation package "SAPK-110COINMED" (type &4"AOI") for Add-On &2"MED" rel.&3"110_600"

3 ETN245 The following import prerequisites of OCS Package "SAPK-110COINMED" have not been met:

3 ETN264 In the (alternatively) Requirement set "01":

3WETN492 Required Add-On component "IS-H" rel."600" is not installed

3WETN491 Required software component "SAP_APPL" rel."600" is not installed3 ETN490 Use the Add-On installation package "SAPK-110EXINMED" (type &4"AOX") for Add-On &2"MED" rel.&3"110_600"

3 ETN245 The following import prerequisites of OCS Package "SAPK-110EXINMED" have not been met:

3 ETN264 In the (alternatively) Requirement set "01":

3WETN492 Required Add-On component "IS-H" rel."600" is not installed

3WETN491 Required software component "SAP_APPL" rel."600" is not installed

2WETN543 OCS package "SAPK-110EXINMED" does not match the current software component vector

Can some one help me to help with this issue?

Thank you very much!

regards

Jürgen