on 03-20-2009 1:50 PM
Dear QM Gurus,
i have created class, i have created characteristics (CT04), now after completion of result recording and even UD. The values are not getting update in batch. please guide.
thanks in advance
kailash thakkar
Hi kailash
Try this.........
1.Create a characteristic of type Num or Char and assign the selected set to the characteristic. (Go to values tab in characteristic and click on other values option and choose selected set).
2.Assign the same characteristic in MIC.
3.Create a batch class and assign the same characteristic, and assign the batch class in the material master.
4.Carry out the std QM cycle
Note :-
The prerequisites that must be fulfilled in order to assign a class characteristic in MIC depends on whether the class characteristic is of the data type "NUM" or "CHAR."
If the general characteristic is of the data type "NUM," the following conditions must be fulfilled:
The master inspection characteristic must be quantitative.
The two characteristics must have identical units of measurement, if a unit is assigned to the class characteristic.
The control indicator for the upper specification limit and the control indicator for the lower specification limit must be set in the master inspection characteristic.
The interval limits for the class characteristic must be maintained as follows:
Master insp. characteristic Class characteristic
Lower spec. limit only lower limit, no upper limit
Upper spec. limit only upper limit, no lower limit
Both specification limits both upper and lower limit
If the class characteristic is of the type "CHAR," the following conditions must be fulfilled:
A selected set from catalog type 1 was assigned to the class characteristic.
The master inspection characteristic is qualitative.
The "Characteristic attribute" indicator is set for the master inspection characteristic
settings:
Go to QCC0->Quality inspection->Inspection lot completion-->transfer inspection decision to batch
Check it
Regards
Sujit S Gujar
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
1.I hope you have now created char (MIC with Class type 23) now You must have used it in QP01.
2.Now create a lot using MSC1N
3.create a inpecion lot(migo)
4.While result recoding system will ask for batch,Enter bach you have created in MSC1N..
5.Take UD .save
All the char will be get copied to batch as per spro setting .these result can be seen in batch MSC3N.
Regards
Sujit
thanks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
I believe you have created inspections specification for the material to transfer the inspection results to the batch.
regards
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
96 | |
10 | |
9 | |
6 | |
3 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.