Hr Object analysis in RAR 5.3

[Former Member]

Hi Guys

We are using position based security.

I was trying to run Risk analysis report on HR Object basis. When I run it on the basis of

Object Type = Position

Analysis Type =Object security only

It shows me the SOD conflicts within the roles attached to that position. However when i try to run the report for user attached to that position with following criteria

Object Type = Position

Analysis Type = User Analysis

Is say no SOD conflict found. I Checked in ERP that user is attached to the position, Role are also attached to the user master record.

I was just wondering if I need to do some extra configuration??

Parveen

[hkaur · Accepted solution]

Hi Praveen,

This should not happen if your position has risks and its assigned to some users. Can you make sure that user sync job was completed and all users were synched properly?

Regards

Harleen

[Former Member · Accepted solution]

Hi

I did full user sync today also but still the same problem..

I could see my user and the roles assigned to it in the compliance calibrator but when I do SOD analysis the report say no SOD Found

Any other guess

Parveen

[Former Member]

HR position bases analysis works if user is assigned to position via personnal record and roles are assigned to position as well

In our case we are not using personal records so it was unable to link users to position.

Parveen

[Former Member]

Thanks for sharing the solution that you found yourself