Skip to Content
avatar image
Former Member

inspection result va;ues copy from batch characteristic value.

hello,

any pls explain me my client wants inspection results values to be copied from batch characteristc values. just he wants to do the value is approved or rejected thats all. how can i map this.

thanks &regards

bhakta.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • Best Answer
    avatar image
    Former Member
    Mar 12, 2009 at 06:46 AM

    Hi

    1.Create a characteristic of type Num or Char and assign the selected set to the characteristic. (Go to values tab in characteristic and click on other values option and choose selected set).

    2.Assign the same characteristic in MIC.

    3.Create a batch class and assign the same characteristic, and assign the batch class in the material master.

    4.Carry out the std QM cycle

    Note :-

    The prerequisites that must be fulfilled in order to assign a class characteristic in MIC depends on whether the class characteristic is of the data type "NUM" or "CHAR."

    If the general characteristic is of the data type "NUM," the following conditions must be fulfilled:

    The master inspection characteristic must be quantitative.

    The two characteristics must have identical units of measurement, if a unit is assigned to the class characteristic.

    The control indicator for the upper specification limit and the control indicator for the lower specification limit must be set in the master inspection characteristic.

    The interval limits for the class characteristic must be maintained as follows:

    Master insp. characteristic Class characteristic

    -


    Lower spec. limit only lower limit, no upper limit

    Upper spec. limit only upper limit, no lower limit

    Both specification limits both upper and lower limit

    If the class characteristic is of the type "CHAR," the following conditions must be fulfilled:

    A selected set from catalog type 1 was assigned to the class characteristic.

    The master inspection characteristic is qualitative.

    The "Characteristic attribute" indicator is set for the master inspection characteristic.

    Regards

    S.Senthil

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi

      For example if you are measuring width/length in Quality. In resulting recording what ever value your are entering for width/length will be automatically updated in the specific batch. As usual you can do the UD and reject or accept the lot.

      As for as I know passing the length/width value from batch to result recording is not possible.

      Please let me know if u need further details.

      Regards

      S.Senthil

      Edited by: Senthilkumar Sivaramakrishnan on Mar 12, 2009 12:12 PM

  • avatar image
    Former Member
    Mar 12, 2009 at 06:44 AM

    Hi bahkta

    Go to QCC0->Quality inspection->Inspection lot completion-->transfer inspection decision to batch

    The settings are relevant to the inspection type and the plant of the inspection lot into which the results are to be copied.

    Whenever you do result recoring for a batch all values will be copied to batch can be seen in MSC3N.

    Results history can be seen in the same.

    I hope this will help

    Sujit

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Mar 25, 2009 at 05:56 PM

    i am closing this thred

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Mar 26, 2009 at 06:15 AM

    Hi,

    Copy Inspection results from RR screen to batch is possible but from Batch to RR screen is not possible.

    Regards

    Neeraj

    Add comment
    10|10000 characters needed characters exceeded