RFC_READ_TABLE for KONV table

[Former Member]

Hi All,

I am using the function module RFC_READ_TABLE to retrieve data in KONV table of R/3.

Unfortunately, it is giving me a sy-subrc = 7.

Is it possible to use this function module to KONV table?

Are there limitations on the query table to be used in this FM?

Regards,

Kezia

[Former Member]

Hi:

try Function Module WCB_READ_KONV

Regards

Shashi

[Former Member]

>

> Hi:
> try Function Module WCB_READ_KONV
> Regards
> Shashi

Hi Shashi,

Thanks for your reply.

But I need an RFC-enabled FM that will retrieve the PO conditions in R/3. I will be using it in SRM.

Hence, I cannot use WCB_READ_KONV FM in R/3.

I tried using RFC_READ_TABLE FM on other system and was able to execute it correctly using KONV. However, when I tried using it to another system (same version ECC 6.0), it gives me a runtime error ASSIGN_BASE_WRONG_ALIGNMENT - Error in ASSIGN assignment in program "SAPLSDTX".

Many thanks,

Kezia

[Former Member]

Look at SAP note : 794193 , 765082 which tells what might be the problem ..

[former_member156446]

I doubt as KONV beeing a cluster table...

[Former Member]

Have read posts in the web encountering same problem and ended up copying and then modifying the function module.

Instead of copying this FM, I will just copy WCB_READ_KONV FM suggested by Shashi and just activate its remote-enabled function.

Thank you!

Kezia

[Former Member]

Hi Kezia,

I faced the same problem, and after much analysis, I found the problem...

And the problem is that the structure of table in source and destination did not matched,

that is bcz it was giving the subrc 7.

In my case i cannot even make a RFC at destination.

but,

I hope this helps you..

Thanks,