Skip to Content
avatar image
Former Member

Problems with copy of WS14000044 workflow.

Hi all.

I'm newbie in SRM. I have two problems.

Fisrt Problem: I'm using a copy of WS14000044 workflow, but in this it the buttons to add reviwer or approval are disabled. Why? What is the problem? How can I solve it?

Second problem: I would like to change the behaviour so that the requester should not approve the SC anymore. SC should go straight forward towards next step (e.g. manager's approval). How should I change the copy of WS14000044 to make this kind of behaviour to occur?

Many thanks.



Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • avatar image
    Former Member
    Mar 10, 2009 at 08:05 AM


    check whether the event linkage is active.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member


      WD:344 This node violates ...

      to eliminate this one , call swdd, choose the WS14000044, and go to menu

      Extras/Special function/block correction.

      but this should not cause the problems you have described.

      The problem is here:

      "I have eliminated the two last steps (Set Status (14) "Resubmit and Start Again" and Present Changes to Creator) "

      The step Present changes - this is where the process goes to requestor and he says ok, then the approval WFl get started. if you have deleted this step, there will be no wfl started...