Skip to Content
avatar image
Former Member

Message communiation using JMS adapter

Hi Expert,

can anyone please explain the message communication using JMS adapters, like how it uses the beans specified in the module and how it get converted to XML message in XI .

If I am using a scenario that is sending a flatfile and a specific MQ series is used here.

Thanks

Sugata B

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Best Answer
    avatar image
    Former Member
    Mar 06, 2009 at 09:48 PM

    Sugata:

    SAP XI / PI support a couple of JMS queues, therefore, you need to deploy vendor specific driver first:

    How to Install and configure external drivers for JDBC JMS (Deploy)

    https://www.sdn.sap.com/irj/sdn/go/portal/prtroot/docs/library/uuid/f04ce027-934d-2a10-5a8f-fa0b1ed4d88f

    If you use JMS sender adapter, means that you create JMS adapter to pick up file from the queue.

    The sender application system will put the message into the queue.

    If the message put into the queue is flat file, and you would like to convert it to xml format,

    JMS file content conversion is needed. When you came cross this situation, the conversion can be done silimar like you do

    on your file sender adapter. But for JMS this is done on Module tab, there is how to document for it.

    You will use message transformationBean:

    http://help.sap.com/saphelp_nw04s/helpdata/en/57/0b2c4142aef623e10000000a155106/frameset.htm

    Hope clarify your doubt

    Regards.

    Liang

    Edited by: Liang Ji on Mar 6, 2009 10:52 PM

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Mar 06, 2009 at 10:14 PM
    Add comment
    10|10000 characters needed characters exceeded