Skip to Content
0
Former Member
Mar 05, 2009 at 07:53 AM

Error while installing Equipment using IE4N

701 Views

Hi All,

I am working in ECC 6.0, in which when I am using T Code IE4N (Dismantling/Installation of eqpt.) for installation of equipment. When I am trying to do this system issues a error:

At least one error was reported by the installation check routines

Message no. IEN130

Diagnosis

At least one message with a serious error has been reported while performing the different checks and validations for the equipment installation.

System Response

The installation process is aborted. The system cannot save your entries.

Procedure

Open the application log and verify all error messages. You can either try to correct the error, if possible, or activate the "Forced Installation Mode" to overrule the check results. In either case, save your entries again to restart the installation process.

When I checked further, system allows me to do force installation of equipment.

Is there any problem in doing force installation / dismantling?

How to overcome this, I mean doing installation without forcibly.

If anyone has any information on this config control settings, kindly furnish details. It would be of great help to me.

Many thanks in advance.......Best Regards

Narendra