Skip to Content
0
Former Member
Mar 03, 2009 at 10:10 PM

Connection between Inspection Types and Movement Types

1223 Views

Hi Everyone,

I have setup a custom inspection 08ST for stock transfers. I have the following questions :

1. If I activate both 08 and 08ST for a material, which one will the system pick when a lot is generated ?

2. Does the selection of Inspection Type depends only on the PREFERRED check box in the QM View of Material Master

3. Is there any connection between Movement Type and Inspection Type ? If yes, where can I see it ?

Regards,

Manish.